pair

Good evening all. Newbie and first thread I have a 2019 cbr650r and just done the pair valve mod. Also has a full titanium akra and mwr race filter in. Experience of the pair valve mod is the same at idle and has eliminated all the excess pops and crackles when revving static. I am yet to ride...

I’ve checked out a few threads about a ticking/clicking noise but none seem as bad as this & all others seem to have been classed as normal I’ve attached two videos one at idle speed and one at 1800RPM, the ticking seems to be present right the way through the rev range... this noise is loud...

Hey there everyone. My name is Vanta and I just snagged myself a leftover new 2018 CB650F this morning. Been swooning over this bike since I’ve came across it at a dealer a few years back. I’ve owned a CB500F prior to this and a Rebel 250 prior to that. I’ve got a simple question. Anyone else...

STEP 1: Buy Smart Moto Blanking plates for the CB/CBR650F from Ebay. (think no one needs instructions for this!) STEP 2: LEFT HAND PAIR PORT - Blanking plate, two aln bolts with washers STEP 2: Flip the blanking plate over and use insulation tape on the end where the reed valve screw heads...

Updating from old site as a few people have enquiries about the mod: Reasons For: Throttle is buttery smooth all the way up and down the line in all gears. No garbled noises or stutters on deceleration just smooth linear transitions. Approx 6 hours maximum to complete. It's a simple mod in...